In the Web interface Settings, you can change the port number used to access the Barracuda Message Archiver administration interface.(Optional but highly recommended for your security and protection) Specify the Administrator IP/Range addresses/networks that can access the administrative web interface for the Barracuda Message Archiver.Note that the system reboots when the time zone is changed. Verify the Time Zone this setting determines the delivery times for messages.(Optional but highly recommended for your security and protection) In the Password Change section, change the system password for the admin account if you have not already done so.Go to the Basic > Administration page and perform the following steps: Whenever your Barracuda Message Archiver IP address is changed on the Basic > IP Configuration page, you are disconnected from the administration interface log in again using the new IP address. Enter the default hostname and default domain name of the Barracuda Message Archiver.Verify the primary and secondary DNS servers for your Barracuda Message Archiver.In the TCP/IP Configuration section, verify the IP address, netmask, default gateway for your Barracuda Message Archiver.Go to the Basic > IP Configuration page and perform the following steps:.Set a new administrator password and click Update Password. Note that the new password cannot be admin or the serial number. For help finding the serial number of your appliance, see Serial Number for Hardware and Virtual Appliances.įor security purposes, you must change the default password of the administrator account. If your serial number is 1311431 or lower, then the default administrator password is admin. If your appliance serial number is higher than 1 311431, then the default administrator password is the numeric portion of the serial number. Log into the administration interface by entering admin for the username and for the password:.From a web browser, enter followed by the IP address of the Barracuda Message Archiver, followed by the default Web Interface HTTP Port (:8000).To configure this setting, go to the Advanced > Secure Administration page in the Barracuda Message Archiver web interface. In addition, Barracuda Networks recommends requiring HTTPS to connect to the Barracuda Message Archiver. To ensure the highest security, use HTTPS to configure your Barracuda Message Archiver web interface.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |